1. The temperature of electronic structural adhesive is best controlled within the temperature specified in the product instructions, and placed in a dry and cool place and kept away from light.

2. The air is discharged before the use of electronic structural adhesive, and then the gap is filled continuously and evenly, without bubbles, so as to ensure the good bonding effect.

3. If the temperature is low, heat or prolong the curing time.

4. Because the dust and other residues on the surface of the electronic structural adhesive will hinder the bonding, it is necessary to strictly clean the bonding material before use to ensure that the structural adhesive and the substrate are bonded well.

5, the electronic structure glue can not contact the skin directly. Electronic structural gels are made up of chemicals that, once in contact with the skin, not only irritate the skin, but are also difficult to remove. Therefore, when using electronic structural adhesive, wear work clothes and protective gloves to avoid direct contact with skin.